Install The Riser Cage - HPE ProLiant DL325 Gen10 Plus v2 User Manual

Install the riser cage

Install the riser cage
Procedure Procedure
1. If an expansion card or its internal cabling was removed, reinstall these components.
2. Install the primary riser cage:
a. Carefully press the riser down on its system board connector (callout 1).
Make sure that the riser board is firmly seated.
b. Simultaneously push and rotate the half-turn spring latch to 180° (callout 2).
c. Close the spring latch (callout 3).
3. Install the secondary riser cage:
a. Align the arrows on the riser cage with the arrows on the power supply cage (callout 1).
b. Carefully press the riser down on its system board connector (callout 2).
Make sure that the riser board is firmly seated.
c. Simultaneously push and rotate the half-turn spring latch to 180° (callout 3).
d. Close the spring latch (callout 4).
Install the riser cage 57