Remove The Riser Cage - HPE ProLiant DL325 Gen10 Plus v2 User Manual

Remove the riser cage

Remove the riser cage
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the WARNING:
internal system components to cool before touching them.
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, release the cable management arm.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. If an expansion card with internal cables is installed on the riser, disconnect the cables from the card.
10. Release the half-turn spring latch (callouts 1 and 2), and then lift the riser cage off the system board (callout 3).
Primary riser cage
Remove the riser cage 52