Remove The Server From The Rack - HPE ProLiant DL325 Gen10 Plus v2 User Manual

Remove the server from the rack

Remove the server from the rack
Prerequisites Prerequisites
Before you perform this procedure, review the:
Rack warnings and cautions
Server warnings and cautions
A fully populated server is heavy. Hewlett Packard Enterprise recommends removing the external chassis components before
removing the server from the rack.
Before you perform this procedure, make sure that you have a T-25 Torx screwdriver available.
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, release the cable management arm.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Extend the server from the rack:
a. Open the chassis ear latch (callout 1).
b. If necessary, use a T-25 Torx screwdriver to loosen the shipping screws (callout 2).
c. Slide the server out of the rack until the server rail-release latches are engaged (callout 3).
Remove the server from the rack 41