Removing And Replacing The System Battery - HPE ProLiant DL325 Gen10 Plus v2 User Manual

Removing and replacing the system battery

Removing and replacing the system battery
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, release the cable management arm.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. If an expansion card is installed in the riser slot 2, remove the primary riser cage .
10. Locate the battery on the system board .
11. Remove the system battery.
Removing and replacing the system battery 243