Installing An Optical Drive In The Sff Drive Chassis - HPE ProLiant DL325 Gen10 Plus v2 User Manual

Installing an optical drive in the SFF drive chassis

Installing an optical drive in the SFF drive chassis
Prerequisites Prerequisites
In the SFF drive chassis, the optical drive installation requires the optical drive enablement option kit (P39144-B21).
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
T-15 Torx screwdriver
Phillips No. 1 screwdriver
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, release the cable management arm.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the rack sliding rails.
9. Remove the universal media bay blank.
Retain the blank for future use.
Installing an optical drive in the SFF drive chassis 117