Table of Contents
Advertisement
Installing an internal USB device
Procedure
1.
Power down the server on page 23.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
•
Server in rack mode: Remove the server from the rack on page 23.
•
Server in tower mode: Position the tower server for hardware configuration on page 25.
5.
Remove the access panel on page 25.
6.
Remove the PCI air baffle on page 29.
7.
Remove the system air baffle on page 30.
8.
Locate the internal USB connector.
9.
Plug in the USB device into the internal USB port.
10. Install the system air baffle on page 31.
11. Install the PCI air baffle on page 30.
12. Install the access panel on page 26.
13. Do one of the following:
•
Server in rack mode: Install the server into the rack on page 53.
•
Server in tower mode: Return the server to an upright position.
90
Hardware options installation
Advertisement
Table of Contents
