Installing an internal USB device
Procedure
1.
Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
Server in rack mode: Remove the server from the rack.
•
•
Server in tower mode: Position the tower server for hardware configuration.
5.
Remove the access panel.
6.
Remove the PCI air baffle.
7.
Remove the system air baffle.
8.
Locate the internal USB connector.
9.
Plug in the USB device into the internal USB port.
10. Install the system air baffle.
11. Install the PCI air baffle.
12. Install the access panel.
13. Do one of the following:
Hardware options installation
103