Installing A Type-P Pcie Plug-In Controller Option - HPE ProLiant DL325 Gen10 Plus v2 User Manual

Installing a type-p PCIe plug-in controller option

Installing a type-p PCIe plug-in controller option
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots have either CAUTION:
a riser slot blank or an expansion card installed.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
Compatible controller cable option
T-15 Torx screwdriver
Phillips No. 1 screwdriver
The flash-backed write cache (FBWC) feature of some storage controllers requires the energy pack option. For more information,
see the controller QuickSpecs on the Hewlett Packard Enterprise website (https://www.hpe.com/info/qs
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, release the cable management arm.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. Identify the riser slot compatible with the storage controller .
https://www.hpe.com/info/qs).
Installing a type-p PCIe plug-in controller option 148