Installing The Chassis Intrusion Detection Switch - HPE ProLiant DL325 Gen10 Plus v2 User Manual

Installing the chassis intrusion detection switch

Installing the chassis intrusion detection switch
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. If installed, release the cable management arm.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel .
9. Insert the switch holder tabs into the chassis slots until the holder clicks into place.
Installing the chassis intrusion detection switch 179