10. If the controller cable is not yet connected to the drive backplane, remove the front drive cage to facilitate the cabling .
11. Cable the controller .
12. If removed, install the front drive cage .
13. Install the access panel .
14. Install the server into the rack .
15. Connect all peripheral cables to the server.
16. Connect each power cord to the server.
17. Connect each power cord to the power source.
18. If installed, close the cable management arm.
19. Power up the server .
20. If removed, install the front bezel .
21. To configure drive arrays, see the following documentation for detailed instructions:
Installing a type-a modular controller option
146