Adapting The Measuring Device To The Process; Conditions; Performing A Totalizer Reset - Endress+Hauser Proline Promass E 500 PROFINET Operating Instructions Manual

Operation
Parameter
Output frequency 1 to n
Pulse output 1 to n
Switch status 1 to n
Parameter
Switch status
Switch cycles
Max. switch cycles number
168
Parameter overview with brief description
Prerequisite
In the Operating mode parameter, the
Frequency option is selected.
The Pulse option is selected in the
Operating mode parameter parameter.
The Switch option is selected in the
Operating mode parameter.
Output values for relay output
The Relay output 1 to n submenu contains all the parameters needed to display the
current measured values for every relay output.
Navigation
"Diagnostics" menu → Measured values → Output values → Relay output 1 to n
‣
Relay output 1 to n
Switch status
Switch cycles
Max. switch cycles number
Parameter overview with brief description
Description
Shows the current relay switch status.
Shows number of all performed switch cycles.
Shows the maximal number of guaranteed switch cycles.
11.5

Adapting the measuring device to the process

conditions

The following are available for this purpose:
• Basic settings using theSetup menu (→  109)
• Advanced settings using theAdvanced setup submenu (→  140)
11.6

Performing a totalizer reset

The totalizers are reset in the Operation submenu:
• Control Totalizer
• Reset all totalizers
Proline Promass E 500 PROFINET
Description
Displays the value currently measured
for the frequency output.
Displays the pulse frequency currently
output.
Displays the current switch output
status.
• Open
• Closed
Positive integer
Positive integer
User interface
0.0 to 12 500.0 Hz
Positive floating-point
number
• Open
• Closed
→  168
→  168
→  168
User interface
Endress+Hauser