Endress+Hauser Proline Promass E 500 PROFINET Operating Instructions Manual page 127

Proline Promass E 500 PROFINET
Parameter
Minimum frequency value
Maximum frequency value
Measuring value at minimum
frequency
Measuring value at maximum
frequency
Failure mode
Failure frequency
Invert output signal
* Visibility depends on order options or device settings
Endress+Hauser
Prerequisite
The Frequency option is
selected in the Operating
mode parameter (→  122)
and a process variable is
selected in the Assign
frequency output parameter
(→  126).
The Frequency option is
selected in the Operating
mode parameter (→  122)
and a process variable is
selected in the Assign
frequency output parameter
(→  126).
The Frequency option is
selected in the Operating
mode parameter (→  122)
and a process variable is
selected in the Assign
frequency output parameter
(→  126).
The Frequency option is
selected in the Operating
mode parameter (→  122)
and a process variable is
selected in the Assign
frequency output parameter
(→  126).
The Frequency option is
selected in the Operating
mode parameter (→  122)
and a process variable is
selected in the Assign
frequency output parameter
(→  126).
The Frequency option is
selected in the Operating
mode parameter (→  122)
and a process variable is
selected in the Assign
frequency output parameter
(→  126).
–
Description
Enter minimum frequency.
Enter maximum frequency.
Enter measured value for
minmum frequency.
Enter measured value for
maximum frequency.
Define output behavior in
alarm condition.
Enter frequency output value
in alarm condition.
Invert the output signal.
Commissioning
Selection / User Factory setting
interface / User
entry
0.0 to 10 000.0 Hz 0.0 Hz
0.0 to 10 000.0 Hz 10 000.0 Hz
Signed floating-point Depends on country
number and nominal
diameter
Signed floating-point Depends on country
number and nominal
diameter
• Actual value 0 Hz
• Defined value
• 0 Hz
0.0 to 12 500.0 Hz 0.0 Hz
• No No
• Yes
127