Repair; General Notes; Repair And Conversion Concept; Notes For Repair And Conversion - Endress+Hauser Proline Promass E 500 PROFINET Operating Instructions Manual

Repair

248
14 Repair
14.1

General notes

14.1.1

Repair and conversion concept

The Endress+Hauser repair and conversion concept provides for the following:
• The measuring devices have a modular design.
• Spare parts are grouped into logical kits with the associated Installation Instructions.
• Repairs are carried out by Endress+Hauser Service or by appropriately trained customers.
• Certified devices can only be converted to other certified devices by Endress+Hauser
Service or at the factory.
14.1.2

Notes for repair and conversion

For repair and modification of a measuring device, observe the following notes:
‣
Use only original Endress+Hauser spare parts.
‣
Carry out the repair according to the Installation Instructions.
‣
Observe the applicable standards, federal/national regulations, Ex documentation (XA)
and certificates.
‣
Document every repair and each conversion and enter them into the W@M life cycle
management database.
14.2

Spare parts

Measuring device serial number:
Can be read out via the Serial number parameter (→  244) in the Device
information submenu.
14.3

Endress+Hauser services

Endress+Hauser offers a wide range of services.
Your Endress+Hauser Sales Center can provide detailed information on the services.
14.4

Return

The requirements for safe device return can vary depending on the device type and
national legislation.
1. Refer to the website for more information:
http://www.endress.com/support/return-material
2. Return the device if repairs or a factory calibration are required, or if the wrong
device was ordered or delivered.
14.5

Disposal

14.5.1

Removing the measuring device

1. Switch off the device.
Proline Promass E 500 PROFINET
Endress+Hauser