Defining The Tag Name; Setting The System Units - Endress+Hauser Proline Promass E 500 PROFINET Operating Instructions Manual

Commissioning
Parameter
Name of station
110
‣
Relay output 1 to n
‣
Display
‣
Low flow cut off
‣
Partially filled pipe detection
‣
Advanced setup
10.5.1

Defining the tag name

A measuring point can be quickly identified within a plant on the basis of the tag name.
The tag name is equivalent to the device name (name of station) of the PROFINET
specification (data length: 255 bytes)
The device name can be changed via DIP switches or the automation system .
The device name currently used is displayed in the Name of station parameter.
Navigation
"Setup" menu → Name of station
Parameter overview with brief description
Description
Name of the measuring point.
10.5.2

Setting the system units

In the System units submenu the units of all the measured values can be set.
The number of submenus and parameters can vary depending on the device version.
Certain submenus and parameters in these submenus are not described in the
Operation Instructions. Instead a description is provided in the Special Documentation
for the device (→ "Supplementary documentation" section).
Navigation
"Setup" menu → System units
‣
System units
Mass flow unit
Mass unit
Volume flow unit
Volume unit
Corrected volume flow unit
Proline Promass E 500 PROFINET
User interface
Max. 32 characters such as
letters and numbers.
→  131
→  134
→  138
→  139
→  140
Factory setting
EH-PROMASS500 serial
number of the device
→  111
→  111
→  111
→  111
→  111
Endress+Hauser