Proline Promass E 500 PROFINET
Parameter
Assign status
Switch-on value
Switch-off value
Switch-on delay
Switch-off delay
Failure mode
Invert output signal
*
Visibility depends on order options or device settings
Endress+Hauser
Prerequisite
• The Switch option is
selected in the Operating
mode parameter.
• The Status option is
selected in the Switch
output function parameter.
• The Switch option is
selected in the Operating
mode parameter.
• The Limit option is selected
in the Switch output
function parameter.
• The Switch option is
selected in the Operating
mode parameter.
• The Limit option is selected
in the Switch output
function parameter.
• The Switch option is
selected in the Operating
mode parameter.
• The Limit option is selected
in the Switch output
function parameter.
• The Switch option is
selected in the Operating
mode parameter.
• The Limit option is selected
in the Switch output
function parameter.
–
–
10.5.10 Configuring the relay output
The Relay output wizard guides the user systematically through all the parameters that
have to be set for configuring the relay output.
Navigation
"Setup" menu → Relay output 1 to n
‣
RelaisOutput 1 to n
Switch output function
Assign flow direction check
Assign limit
Assign diagnostic behavior
Description
Select device status for switch
output.
Enter measured value for the
switch-on point.
Enter measured value for the
switch-off point.
Define delay for the switch-on
of status output.
Define delay for the switch-off
of status output.
Define output behavior in
alarm condition.
Invert the output signal.
Commissioning
Selection / User
Factory setting
interface / User
entry
• Partially filled pipe
Partially filled pipe
detection
detection
• Low flow cut off
*
• Profinet Slot 24
*
• Profinet Slot 25
*
• Profinet Slot 26
Signed floating-point
Country-specific:
number
• 0 kg/h
• 0 lb/min
Signed floating-point
Country-specific:
number
• 0 kg/h
• 0 lb/min
0.0 to 100.0 s
0.0 s
0.0 to 100.0 s
0.0 s
• Actual status
Open
• Open
• Closed
• No
No
• Yes
→ 132
→ 132
→ 133
→ 133
131