Table of Contents
Advertisement
Commissioning
Parameter
Switch-off value
Switch-off delay
Switch-on value
Switch-on delay
Failure mode
*
Visibility depends on order options or device settings
134
Prerequisite
In the Relay output function
parameter, the Limit option is
selected.
In the Relay output function
parameter, the Limit option is
selected.
The Limit option is selected in
the Relay output function
parameter.
In the Relay output function
parameter, the Limit option is
selected.
–
10.5.11 Configuring the local display
The Display wizard guides you systematically through all the parameters that can
configured for configuring the local display.
Navigation
"Setup" menu → Display
‣
Display
Format display
Value 1 display
0% bargraph value 1
100% bargraph value 1
Value 2 display
Value 3 display
0% bargraph value 3
100% bargraph value 3
Value 4 display
Description
Enter measured value for the
switch-off point.
Define delay for the switch-off
of status output.
Enter measured value for the
switch-on point.
Define delay for the switch-on
of status output.
Define output behavior in
alarm condition.
Proline Promass E 500 PROFINET
Selection / User
Factory setting
interface / User
entry
Signed floating-point
Country-specific:
number
• 0 kg/h
• 0 lb/min
0.0 to 100.0 s
0.0 s
Signed floating-point
Country-specific:
number
• 0 kg/h
• 0 lb/min
0.0 to 100.0 s
0.0 s
• Actual status
Open
• Open
• Closed
→ 135
→ 136
→ 137
→ 137
→ 137
→ 137
→ 137
→ 137
→ 137
Endress+Hauser
Advertisement
Table of Contents
