ABB AC500 PLC Hardware Manual page 1092

Device Specifications
Communication Interface Modules (S500) > PROFINET
Name
Handshake mode
Baudrate
Parity
Data bits
Stop bits
1092
Value
None
XON/XOFF
Channel inactive
300 bit/s
1200 bit/s
4800 bit/s
9600 bit/s
14400 bit/s
19200 bit/s
38400 bit/s
38400 bit/s
57600 bit/s
115200 bit/s
No parity
Odd parity
Even parity
5 bits
6 bits
7 bits
8 bits
1 bit
2 bits
Configuration with Automation Builder
The physical layers are selectable as submodules in PROFINET configuration
(parameter Physical Layer not visible and fixed with the correct value). Certain
parameters are not visible if a certain physical layer is selected. This concept of
parameterization provides a better usability than configuring via GSDML (see
below).
Configuration via GSDML (use by non-ABB PROFINET configuration tool)
All parameters are visible independent of the configured physical layer (via
parameter "Physical Layer" ). The user must take precautions for each param-
eter since certain parameter values are invalid for certain physical layers. Nev-
ertheless, the CI5xx-PNIO module performs a parameter check depending on
the configured physical layer and generates a diagnosis message (parameter
error) in the case of error.
3ADR010121, 13, en_US
Internal value Internal
value, type
0 BYTE
2
0 DWORD
300
1200
4800
9600
14400
19200
38400
57600
57600
115200
0 BYTE
1
2
0 BYTE
1
2
3
0 BYTE
1
Default
0
19200
No parity
8
1
2019/04/17