ABB AC500 PLC Hardware Manual page 1290

System Assembly, Construction and Connection
AC500 (Standard) > Connection and Wiring
Parameter
Wave impedance [Ohms]
Category
Class
TP Cable The TP cable has eight wires arranged in four pairs of twisted wires. Different color codes exist
for the coding of the wires, the coding according to EIA/TIA 568, version 1, being the one most
commonly used. In this code, the individual pairs are coded with blue, orange, green and brown
color. One wire of a pair is unicolored and the corresponding second wire is striped, the respec-
tive color alternating with white. For shielded cables, a distinction is made between cables that
have one single shield around all pairs of wires and cables that have an additional individual
shield for each pair of wires. The following table shows the different color coding systems for TP
cables:
Table 221: Color coding of TP cables:
Pairs
Pair 1
Pair 2
Pair 3
Pair 4
Two general variants are distinguished for the pin assignment of the normally used RJ45 con-
nectors: EIA/TIA 568 version A and version B. The wiring according to EIA/TIA 568 version B is
the one most commonly used.
Fig. 240: Pin assignment of RJ45 sockets
2.6.4.10.3 Cable Types
Crossover cable
1290
10Base-T [10 MHz]
100
3 or higher
C or higher
EIA/TIA 568 EIA/TIA 568
Version 1 Version 2
white/ blue green
blue
white/ orange black
orange
white/ green blue
green
white/ brown brown
brown
Pair 2
Pair 3 Pair 1
1 2 3 4 5 6
T3 R3 T2 R1 T1 R2
T568A
Particular use
Crossover cables are needed only for a direct Ethernet connection without
crossover functionality. In particular for AC500 modules in product life cycle
phase "Classic".
3ADR010121, 13, en_US
DIN 47100
red white
yellow green
orange grey
slate blue
Pair 4 Pair 2
7 8 1
T4 R4 T3
100Base-TX [100 MHz]
100
5
D or higher
IEC 189.2
brown white
yellow white
pink white
red white
Pair 3
Pair 1 Pair 4
2 3 4 5 6 7
R3 T2 R1 T1 R2 T4
T568B
blue
orange
green
brown
8
R4
2019/04/17