ABB AC500 PLC Hardware Manual page 1022

Device Specifications
Communication Interface Modules (S500) > PROFINET
Fig. 192: Connection of analog output loads (voltage)
The following measuring ranges can be configured
on page 1024
Voltage
The function of the LEDs is described under Diagnosis and displays / Displays
1.7.6.2.8 "Diagnosis and State LEDs" on page 1030.
Unused analog outputs can be left open-circuited.
Connection of Analog Output Loads (Current)
The following figure shows the connection of output loads to the analog output AO0. Proceed
with the analog output AO1 in the same way.
1022
-10 V...+10 V
3ADR010121, 13, en_US
Ä Chapter 1.7.6.2.7 "Parameterization"
Load ±10 mA max. 1 channel used
Ä Chapter
2019/04/17