ABB AC500 PLC Hardware Manual page 1089

1.7.6.5.4 Assignment of the Ethernet Ports
The terminal unit for the communication interface module provides two Ethernet interfaces with
the following pin assignment:
Table 189: Pin assignment RJ45 jack:
Interface
1.7.6.5.5 Addressing
1.7.6.5.6 I/O Configuration
The CI506-PNIO stores some PROFINET configuration parameters:
● Slave station name
● Slave station type
● IP address configuration
● MAC address
● Production data
No more configuration data is stored. The serial interfaces and the CANopen interface is config-
ured via software. For details, refer to Parameterization
on page 1090.
2019/04/17
Pin
1
2
3
4
5
6
7
8
Shield
For further information regarding wiring and cable types see chapter Ethernet
Ä Chapter 2.6.4.10 "Ethernet Connection Details" on page 1288.
The module reads the position of the rotary switches only during power-up, i. e.
changes of the switch position during operation will have no effect until the next
module initialization.
3ADR010121, 13, en_US
Communication Interface Modules (S500) > PROFINET
Signal Description
TxD+ Transmit data +
TxD- Transmit data -
RxD+ Receive data +
NC not used
NC not used
RxD- Receive data -
NC not used
NC not used
Cable shield Functional earth
Ä Chapter 1.7.6.5.7 "Parameterization"
Device Specifications
1089