ABB AC500 PLC Hardware Manual page 1016

Device Specifications
Communication Interface Modules (S500) > PROFINET
Connection of Active-type Analog Sensors (Voltage) with Electrically Isolated Power Supply to the Analog
Inputs
The following figure shows the connection of active-type analog sensors (voltage) with electri-
cally isolated power supply to the analog input AI0. Proceed with the analog inputs AI1 to AI3 in
the same way.
The following measuring ranges can be configured
on page 1024:
Voltage
Voltage
The function of the LEDs is described under Diagnosis and displays / Displays
1.7.6.2.8 "Diagnosis and State LEDs" on page 1030.
To avoid error messages from unused analog input channels, configure them as "unused".
Connection of Active-type Analog Sensors (Current) with Electrically Isolated Power Supply to the Analog
Inputs
The following figure shows the connection of active-type analog sensors (current) with electri-
cally isolated power supply to the analog input AI0. Proceed with the analog inputs AI1 to AI3 in
the same way.
1016
Ä Chapter 1.7.6.2.7 "Parameterization"
0 V...10 V
-10 V...+10 V
3ADR010121, 13, en_US
1 channel used
1 channel used
Ä Chapter
2019/04/17