ABB AC500 PLC Hardware Manual page 1028

Device Specifications
Communication Interface Modules (S500) > PROFINET
Internal value
19
*) In the operating modes with 3-wire configuration or with differential inputs, two adjacent
analog inputs belong together (e.g. the channels 0 and 1). In these cases, both channels are
configured in the desired operating mode. The lower address must be the even address
(channel 0). The next higher address must be the odd address (channel 1). The converted
analog value is available at the higher address (channel 1).
Table 168: Channel Monitoring
Internal Value
0 (default)
3
Channel Parameters for the Analog Outputs (2x)
Name
Output 0,
Channel configu-
ration
Output 0, Check
channel
Output 0, Substi-
tute value
Output 1,
Channel configu-
ration
Output 1, Check
channel
Output 1, Substi-
tute value
1028
Operating modes of the analog inputs, individually configurable
3-wire Ni1000 -50 °C...+150 °C *)
Value Internal value
Table Operating Table Operating
modes of the modes of the
analog outputs analog outputs
Ä Further infor- Ä Further infor-
mation mation
on page 1029 on page 1029
Table Channel Table Channel
monitoring monitoring
Ä Table 170 "Ch Ä Table 170 "Ch
annel Monitoring" annel Monitoring"
on page 1029 on page 1029
Table Substitute Table Substitute
value value
Ä Table 171 "Su Ä Table 171 "Su
bstitute Value" bstitute Value"
on page 1029 on page 1029
Table Operating Table Operating
modes of the modes of the
analog outputs analog outputs
Ä Further infor- Ä Further infor-
mation mation
on page 1029 on page 1029
Table Channel Table Channel
monitoring monitoring
Ä Table 170 "Ch Ä Table 170 "Ch
annel Monitoring" annel Monitoring"
on page 1029 on page 1029
Table Substitute Table Substitute
value value
Ä Table 171 "Su Ä Table 171 "Su
bstitute Value" bstitute Value"
on page 1029 on page 1029
3ADR010121, 13, en_US
Check Channel
Plausib(ility), cut wire, short circuit
Not used
Internal value,
type
BYTE
BYTE
WORD
BYTE
BYTE
WORD
Default
0
0
0
0
0
0
2019/04/17