ABB AC500 PLC Hardware Manual page 1159

CTS
DCD
DTR
DSR
FE
RI
RTS
RxD
SGND Signal Ground
TxD
Purpose The TK501 cable connects a 9-pole serial COM interface of a PC with the serial COM2 interface
of PM57x, PM58x and PM59x. It is used for programming purposes.
Electrical Con- The 2 plugs are put on the 2 COM interfaces and tightened there.
nection
Technical Data
Parameter
Connector at the PC (COM interface)
Connector at the Processor Module (COM2)
Cable length
Cable type
Weight
Ordering Data
Part No.
1SAP 180 200 R0001
1.8.2.8 TK502 - Programming Cable
● Cablel on PC side: D-sub, 9-pole, female, RS-232, for COM interface
● Cable on AC500 side: terminal block, 9-pole, female, RS-232, for COM1 interface
● Cable length: 5 m
2019/04/17
Clear To Send
Data Carrier Detect
Data Terminal Ready
Data Set Ready
Functional Earth
Ring Indicator
Request To Send
Receive Data
Transmit Data
With AC500/AC500-eCo processor modules, only the ABB programming cables
TK50x can be used. Other cables may cause communication faults and must
not be used.
*) For planning and commissioning of new installations use modules in Active
status only.
3ADR010121, 13, en_US
Value
D-sub, 9-pole, female
D-sub, 9-pole, male
5 m
LiYCY 5 x 0.14 mm², shielded
220 g
Description
TK501, programming cable
D-sub / D-sub, length: 5 m
Device Specifications
Accessories > AC500 (Standard)
Product Life Cycle Phase *)
Classic
1159