ABB AC500 PLC Hardware Manual page 1082

Device Specifications
Communication Interface Modules (S500) > PROFINET
Parameter
Input data length
Output data length
Max. power dissipation within the module
Setting of the I/O device identifier
Operation and error displays
Weight (without terminal unit)
Mounting position
Cooling
Electrical isolation
Diagnosis
Parameter
Bus connection
Switch
Technology
Transfer rate
Transfer method
1082
Max. load for the terminals
Protection against reversed voltage
Rated protection fuse on UP
Inrush current from UP (at power up)
Current consumption via UP (normal
operation)
Connections
NOTICE!
Attention:
All I/O channels (digital and analog) are protected against reverse polarity,
reverse supply, short circuit and continuous overvoltage up to 30 VDC.
Multiple overloads
No effects of multiple overloads on isolated multi-channel modules occur, as
every channel is protected individually by an internal smart high-side switch.
3ADR010121, 13, en_US
Value
10 A
Yes
10 A fast
On request
0.15 A
Terminals 1.0, 2.0 and 3.0 for +24 V (UP)
Terminals 1.1, 2.1 and 3.1 for 0 V (ZP)
0...36 bytes
0...36 bytes
5 W
With 2 rotary switches at the front side of the
module
18 LEDs (total)
ca. 125 g
Horizontal or vertical
The natural convection cooling must not be hin-
dered by cable ducts or other parts in the
switch-gear cabinet.
Ethernet interface against the rest of the
module, each serial port against each other and
the rest of the module
Ä Chapter 1.7.6.4.7 "Diagnosis"
See Diagnosis
on page 1077
Value
2 x RJ45
Integrated
Hilscher netX100
10/100 Mbit/s (full-duplex)
According to Ethernet II, IEE802.3
2019/04/17