ABB AC500 PLC Hardware Manual page 1010

Device Specifications
Communication Interface Modules (S500) > PROFINET
Terminal
2.6
2.7
2.8
2.9
3.0
3.1
3.2
3.3
3.4
3.5
3.6
3.7
3.8
3.9
1010
Signal
DI6
DI7
UP
ZP
DO0
DO1
DO2
DO3
DO4
DO5
DO6
DO7
UP3
ZP
WARNING!
Removal/Insertion under power
The devices are not designed for removal or insertion under power. Because of
unforeseeable consequences, it is not allowed to plug or unplug devices with
the power being ON.
Make sure that all voltage sources (supply and process voltage) are switched
off before you
– connect or disconnect any signal or terminal block
– remove, mount or replace a module.
Disconnecting any powered devices while energized in a hazardous location
could result in an electric arc, which could create a flammable ignition resulting
in fire or explosion.
Make sure that power is removed and that the area has been thoroughly
checked to ensure that flammable materials are not present prior to proceeding.
The devices must not be opened when in operation. The same applies to the
network interfaces.
NOTICE!
Risk of damaging the PLC modules!
Overvoltages and short circuits might damage the PLC modules.
– Make sure that all voltage sources (supply and process voltage) are
switched off before you begin with operations at the system.
– Never connect any voltages or signals to reserved terminals (marked with
---). Reserved terminals may carry internal voltages.
For the open-circuit detection (cut wire), each analog input channel is pulled up
to "plus" by a high-resistance resistor. If nothing is connected, the maximum
voltage will be read in then.
3ADR010121, 13, en_US
Description
Signal of the digital input DI6
Signal of the digital input DI7
Process voltage UP (24 VDC)
Process voltage ZP (0 VDC)
Signal of the digital output DO0
Signal of the digital output DO1
Signal of the digital output DO2
Signal of the digital output DO3
Signal of the digital output DO4
Signal of the digital output DO5
Signal of the digital output DO6
Signal of the digital output DO7
Process voltage UP3 (24 VDC)
Process voltage ZP (0 VDC)
2019/04/17