ABB AC500 PLC Hardware Manual page 1161

CTS
DCD
DTR
DSR
FE
RI
RTS
RxD
SGND Signal Ground
TxD
Purpose The TK502 cable connects a 9-pole serial COM interface of a PC with the serial COM1 interface
of PM57x, PM58x and PM59x. It is used for programming purposes.
Electrical Con- The 2 plugs are put on the two COM interfaces and the plug at the PC side is tightened then.
nection
Technical Data
Parameter
Connector at the PC (COM interface)
Connector at the AC500 CPU (COM1)
Cable length
Cable type
Weight
Ordering Data
Part No.
1SAP 180 200 R0101
1.8.2.9 TK503 - Programming Cable
● PC-side: USB connector type A
● AC500-side: D-sub, 9-pin, male
● Length 3 m
Intended Pur- TK503 programming cable connects the USB interface of a PC with the serial interface of a pro-
pose cessor module. It is used for programming purposes. TK503 can be used with all AC500 pro-
cessor modules.
2019/04/17
Clear To Send
Data Carrier Detect
Data Terminal Ready
Data Set Ready
Functional Earth
Ring Indicator
Request To Send
Receive Data
Transmit Data
With AC500/AC500-eCo processor modules, only the ABB programming cables
TK50x can be used. Other cables may cause communication faults and must
not be used.
*) For planning and commissioning of new installations use modules in Active
status only.
3ADR010121, 13, en_US
Value
D-sub, 9-pole, female
terminal block, 9-pole, female
5 m
LiYCY 5 x 0.14 mm², shielded
220 g
Description
TK502, programming cable
terminal block / D-sub, length:
5 m
Device Specifications
Accessories > AC500 (Standard)
Product Life Cycle Phase *)
Classic
1161