ABB AC500 PLC Hardware Manual page 1023

Fig. 193: Connection of analog output loads (current)
The following measuring ranges can be configured
on page 1024:
Current
Current
The function of the LEDs is described under Diagnosis and displays / Displays
1.7.6.2.8 "Diagnosis and State LEDs" on page 1030.
Unused analog outputs can be left open-circuited.
Assignment of the Ethernet Ports
The terminal unit for the communication interface module provides two Ethernet interfaces with
the following pin assignment:
Table 165: Pin assignment RJ45 jack:
Interface
2019/04/17
0 mA...20 mA
4 mA...20 mA
Pin Signal
1 TxD+
2 TxD-
3 RxD+
4 NC
5 NC
6 RxD-
7 NC
3ADR010121, 13, en_US
Communication Interface Modules (S500) > PROFINET
Ä Chapter 1.7.6.2.7 "Parameterization"
Load 0 W...500 W
Load 0 W...500 W
Description
Transmit data +
Transmit data -
Receive data +
not used
not used
Receive data -
not used
Device Specifications
1 channel used
1 channel used
Ä Chapter
1023