Softkeys Of The Meas Config Menu; Softkeys Of The Amplitude Menu (Bluetooth Mode) - R&S FSV-K8 Operating Manual

®
R&S FSV-K8

3.4 Softkeys of the MEAS CONFIG menu

The MEAS CONFIG key provides direct access to the submenu of the currently
selected measurement type. For a description of the submenus, see the corresponding
keys in

3.5 Softkeys of the Amplitude Menu (Bluetooth Mode)

The following table shows all softkeys available in the amplitude menu in Bluetooth
mode (AMPT key). It is possible that your instrument configuration does not provide all
softkeys. If a softkey is only available with a special option, model or (measurement)
mode, this information is delivered in the corresponding softkey description.
Ref Level
Opens an edit dialog box to enter the reference level in the current unit (dBm, dBµV,
etc).
The reference level is the maximum value the AD converter can handle without distor-
tion of the measured value. Signal levels above this value will not be measured cor-
rectly, which is indicated by the "IFOVL" status display.
Remote command:
DISPlay[:​ W INDow<n>]:​ T RACe<t>:​ Y [:​ S CALe]:​ R LEVel​
Range Log Manual
Opens an edit dialog box to define the display range of a logarithmic level axis man-
ually.
Remote command:
Logarithmic scaling:
DISP:WIND:TRAC:Y:SPAC LOG, see
SPACing​
Not available for Carr Freq Drift, Init Carr Freq Tol, and Modulation Char measure-
ments.
Display range:
DISPlay[:​ W INDow<n>]:​ T RACe<t>:​ Y [:​ S CALe]​
Range
Opens a submenu to define the display range of the level axis.
Operating Manual 1176.7610.02 ─ 02
Instrument Functions for Bluetooth Measurements (K8)
chapter 3.3, "Softkeys of the Bluetooth
on page 108
Softkeys of the MEAS CONFIG menu
Menu", on page 34.
on page 107
DISPlay[:​ W INDow<n>]:​ T RACe<t>:​ Y :​
on page 105
49