Calculate<N>:Btooth:plength - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
Parameters:
<Mode>
Example:
Usage:
Mode:
Manual operation:
CALCulate<n>:BTOoth:PLENgth?
This command reads the length of the packet analyzed by the preceding measure-
ment.
Note:
This command is only available if a measurement was started via
IMMediate]​
plete measurement the command causes a query error.This command is only available
with the measurements Output Power, Modulation Characteristics, Initial Carrier Fre-
quency Tolerance, and Carrier Frequency Drift (see
MEASurement​
Suffix:
<n>
Example:
Usage:
Mode:
Operating Manual 1176.7610.02 ─ 02
Remote Commands for Bluetooth Measurements (K8)
MINimum | MAXimum | AVERage
*RST: -
For the first steps refer to
ple", on page 127
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
CONF:BTO:SWE:COUN 20
Activates measurement over 20 sweeps.
INIT;*WAI
Activates measurement over 20 sweeps.
CALC:BTO:OPOW:AVER? MAX
Queries the maximum average value of the Output Power mea-
surement.
Query only
BT
See "Output Power"
before and if this measurement is completed. With a missing or incom-
on page 96).
.
irrelevant
INST:SEL BTO
Activates the Bluetooth Measurements option
INIT:CONT OFF
Selects single sweep operation
CONF:BTO:MEAS OPOW
Activates the Output Power measurement
INIT;*WAI
Starts the measurement with synchronization
CALC:BTO:PLEN?
Queries the packet length
Query only
BT
CALCulate subsystem
chapter 4.14, "Programming Exam-
on page 35
CONFigure:​ B TOoth:​
INITiate<n>[:​
84