Configure:btooth:trace<T>:Select - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
The number of measurement to be executed for AVERage, MAXHold and MINHold is
defined with the
note that a synchronization to the end of the indicated number of measurements is only
possible during single sweep operation.
Note:
The setting is valid only for the currently active measurement (see
BTOoth:​ M EASurement​
ments.
Suffix:
<t>
Parameters:
<Mode>
Example:
Mode:
CONFigure:BTOoth:TRACe<t>:SELect
This command selects the measurement curve for evaluation of the modulation char-
acteristics.
Suffix:
<t>
Example:
Mode:
Manual operation:
Operating Manual 1176.7610.02 ─ 02
Remote Commands for Bluetooth Measurements (K8)
CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
CONFigure:​ B TOoth:​ S WEep:​ C OUNt​
on page 96) and independent of the other Bluetooth measure-
.
the trace related to this setting
WRITe | VIEW | AVERage | MAXHold | MINHold | BLANk
*RST: WRITe
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
INIT:CONT OFF
Selects single sweep operation.
CONF:BTO:SWE:COUN 10
Sets the sweep count to 10.
CONF:BTO:TRAC2:MODE AVER
Switches averaging for trace 2 on.
INIT;*OPC
Starts a measurement with synchronization.
BT
.
the trace related to this setting
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS ACLR
Activates the Adjacent Channel Power measurement.
INIT:CONT OFF
Selects single sweep operation.
CONF:BTO:TRAC2:SEL
Selects trace 2 for measurement result queries.
BT
See "Selected Trace"
on page 102 command. Please
CONFigure:​
on page 37
104