R&S FSV-K8 Operating Manual page 59

®
R&S FSV-K8
The abbreviation GFSK stands for "Gaussian Frequency Shift Keying".
Remote command:
CONFigure:​ B TOoth:​ R TPower:​ G AVerage:​ S TARt​
GFSK Stop ← Settings
Defines the stop time for the power measurement of the GFSK sections of the packet.
The default value is 90%.
The abbreviation GFSK stands for "Gaussian Frequency Shift Keying".
Remote command:
CONFigure:​ B TOoth:​ R TPower:​ G AVerage:​ S TOP​
DPSK Start ← Settings
Defines the start time for the power measurement of the DPSK sections of the packet.
The default value is 10%.
The abbreviation DPSK stands for "Differential Phase Shift Keying".
Remote command:
CONFigure:​ B TOoth:​ R TPower:​ D AVerage:​ S TARt​
DPSK Stop ← Settings
Defines the stop time for the power measurement of the DPSK sections of the packet.
The default value is 90%.
The abbreviation DPSK stands for "Differential Phase Shift Keying".
Remote command:
CONFigure:​ B TOoth:​ R TPower:​ D AVerage:​ S TOP​
Gate Delay (Spurious Emissions)
Opens an edit dialog box to enter the time between trigger event and start of the DPSK
packet. That is the measurement start time.
Remote command:
[SENSe:​ ] SWEep:​ E GATe:​ H OLDoff​
Gate Length (Spurious Emissions)
Opens an edit dialog box to enter the sweep time in seconds. Usually, this is the length
of the DPSK section.
Remote command:
[SENSe:​ ] SWEep:​ E GATe:​ L ENGth​
Block Count (Carr Freq Stability)
Opens an edit dialog box to enter the number of blocks to be measured. Every block
has the length of 50 μs. The default value is 200 blocks.
This softkey is only available in single sweep operation.
Remote command:
CONFigure:​ B TOoth:​ C FSTability:​ B COunt​
Operating Manual 1176.7610.02 ─ 02
Instrument Functions for Bluetooth Measurements (K8)
Softkeys of the Sweep Menu (Bluetooth mode)
on page 116
on page 117
on page 94
on page 101
on page 101
on page 100
on page 100
59