®
R&S
FSV-K8
The settings for the measurements of Modulation Characteristics, Initial Carrier Fre-
quency Tolerance, and Carrier Frequency Drift are common to all three measure-
ments.For all other Bluetooth measurements the setting is only valid for the currently
active measurement (see
Parameters:
<Mode>
Example:
Mode:
Manual operation:
CONFigure:BTOoth:BANDwidth|BWIDth:VIDeo <Bandwidth>
This command sets the video bandwidth for the Adjacent Channel Power measure-
ment (see
The available filters have a bandwidth range of 1 Hz to 10 MHz. On a change in video
bandwidth its link according to the RF Test Specification is switched off.
Note:
This setting is only available for Output Power measurements.
Parameters:
<Bandwidth>
Example:
Mode:
Manual operation:
CONFigure:BTOoth:BANDwidth|BWIDth:VIDeo:AUTO <Mode>
This command links the video bandwidth to the settings according to the RF Test
Specification. It is only available for the Adjacent Channel Power measurement (see
CONFigure: B TOoth: M EASurement
Operating Manual 1176.7610.02 ─ 02
Remote Commands for Bluetooth Measurements (K8)
CONFigure: B TOoth: M EASurement
ON | OFF
*RST:
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS MCH
Activates the Modulation Characteristics measurement.
CONF:BTO:BAND:AUTO ON
Activates the RBW coupling.
BT
See
"Res BW Auto (Output Power, TX Spec ACLR, Rel TX
Power, Spurious Emissions)"
CONFigure: B TOoth: M EASurement
1 Hz to 10 MHz
*RST:
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS ACLR
Activates the Adjacent Channel Power measurement.
CONF:BTO:BAND:VID 100HZ
Sets the video bandwidth to 100 Hz.
BT
See
"Video BW Manual (TX Spec ACLR)"
CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
ON
on page 54
on page 96).
AUTO is set to ON
on page 96).
on page 96).
on page 54
93