Calculate<N>:Btooth:mchar:ratio - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
Example:
Usage:
Mode:
Manual operation:
CALCulate<n>:BTOoth:MCHar:RATio? <Mode>
This command determines the ratio of the average frequency deviations for varying bit
patterns of the payload.
Note:
This command is only available with active Modulation Characteristics measurement
(see
ments this command causes a query error.
Suffix:
<n>
Parameters:
<Mode>
Example:
Usage:
Operating Manual 1176.7610.02 ─ 02
For the first steps refer to
ple", on page 127
CONF:BTO:MEAS MCH
Activates the Modulation Characteristics measurement.
CONF:BTO:SWE:COUN 20
Initiates the sweep counter with 20.
... EUT emits bit pattern 10101010
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:MCH:DF2:PERC?
Queries the percentage of "in range" measurements.
Query only
BT
See "Modulation Char"
CONFigure:​ B TOoth:​ M EASurement​
.
irrelevant
MINimum | MAXimum | AVERage
*RST:
For the first steps refer to
ple", on page 127
CONF:BTO:MEAS MCH
Activates the Modulation Characteristics measurement.
CONF:BTO:SWE:COUN 20
Initiates the sweep counter with 20.
... EUT emits bit pattern 1111000
INIT:IMM;*WAI
Starts the measurement with synchronization and erase previ-
ous measurement results.
... EUT emits bit pattern 10101010
INIT:CONM;*WAI
Starts additional measurement with synchronization.
CALC:BTO:MCH:RAT? MIN
Queries the minimum value.
Query only
Remote Commands for Bluetooth Measurements (K8)
chapter 4.14, "Programming Exam-
on page 41
on page 96). With all other measure-
-
chapter 4.14, "Programming Exam-
CALCulate subsystem
82