Table of Contents
Advertisement
®
R&S
FSV-K8
This command is only available with active Modulation Characteristics, Initial Carrier
Frequency Tolerance, and Carrier Frequency Drift measurement (see
BTOoth: M EASurement
query error.
Parameters:
<ReceiveFilter>
Example:
Mode:
Manual operation:
[SENSe:]DDEMod:SEARch:PULSe[:STATe] <Mode>
This command switches the search for a signal burst on or off.
Parameters:
<Mode>
Example:
Mode:
Manual operation:
[SENSe:]DDEMod:SEARch:PULSe:OFFSet <Time>
This command defines the time to be recorded before a signal burst is recognized.
Parameters:
<Time>
Example:
Mode:
Manual operation:
[SENSe]:DDEMod:SEARch:SYNC:STATe <PatternSearch>
This command switches the search for a sync sequence on or off.
Setting parameters:
<PatternSearch>
Operating Manual 1176.7610.02 ─ 02
Remote Commands for Bluetooth Measurements (K8)
SENSe:DDEMod Subsystem (BLUETOOTH, K8)
on page 96). With all other measurements it will lead to a
OFF | BTOoth
*RST:
ON
DDEM:FILT:MEAS BTO
Activates the Bluetooth measurement filter.
BT
See
"Meas Filter (Modulation Char, Init Carr Freq Tol, Carr Freq
Drift)"
on page 55
ON | OFF
*RST:
ON
DDEM:SEAR:PULS OFF
BT
See
"Find Burst On/Off (Output Power)"
0 to 10 ms
*RST:
0
DDEM:SEAR:PULS:OFFS 1MS
Sets the burst offset to 1ms before the start of the burst.
BT
See
"Burst Offset"
on page 39
ON | OFF
*RST:
OFF
CONFigure:
on page 38
121
Advertisement
Chapters
Table of Contents
