Calculate<N>:Btooth:ptype; Calculate<N>:Btooth:rtpower:[Dpsk] - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
CALCulate<n>:BTOoth:PTYPe?
This command determines the type of the packet analyzed by a preceding measure-
ment.
Note:
This command is only available if a measurement was started via
IMMediate]​
plete measurement the command causes a query error.This command is only available
with the measurements Output Power, Modulation Characteristics, Initial Carrier Fre-
quency Tolerance, and Carrier Frequency Drift (see
MEASurement​
Suffix:
<n>
Parameters:
Result
Example:
Usage:
Mode:
CALCulate<n>:BTOoth:RTPower:[DPSK]? <Mode>
This command reads the average transmission power for the DPSK sections of the
packet in the Relative Transmission Power measurement. With a sweep count 1, the
command returns the current value, irrespective of the parameter.
Note:
This command is only available with active Relative Transmit Power measurement
(see
ments this command causes a query error.
Suffix:
<n>
Operating Manual 1176.7610.02 ─ 02
before and if this measurement is completed. With a missing or incom-
on page 96).
.
irrelevant
AUX1 | DH1 | DH3 | DH5 | DM1 | DM3 | DM5 | FHS | HV1 |
HV2 | HV3 | DV | NULL | POLL | UNDEF
These packet types are recognized and returned as character
data.
*RST:
INST:SEL BTO
Activates the Bluetooth Measurements option
INIT:CONT OFF
Selects single sweep operation
CONF:BTO:MEAS OPOW
Activates the Output Power measurement
INIT;*WAI
Starts the measurement with synchronization
CALC:BTO:PTYP?
Queries the packet type
Query only
BT
CONFigure:​ B TOoth:​ M EASurement​
.
irrelevant
Remote Commands for Bluetooth Measurements (K8)
-
on page 96). With all other measure-
CALCulate subsystem
INITiate<n>[:​
CONFigure:​ B TOoth:​
85