Calculate<N>:Btooth:cfstability:ferror:block; Calculate<N>:Btooth:cfstability:ferror:initial - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
Manual operation:
CALCulate<n>:BTOoth:CFSTability:FERRor:BLOCk? <Mode>
This command reads the maximum frequency deviation of all blocks in the Carrier Fre-
quency Stability and Modulation Accuracy measurement.
Note:
This command is only available with active Carrier Frequency Stability and Modulation
Accuracy measurement (see
With all other measurements this command causes a query error.
Suffix:
<n>
Parameters:
<Mode>
Example:
Usage:
Mode:
Manual operation:
CALCulate<n>:BTOoth:CFSTability:FERRor:INITial? <Mode>
This command reads the combined frequency deviation of all packets and all blocks in
the Carrier Frequency Stability and Modulation Accuracy measurement.
Note:
This command is only available with active Carrier Frequency Stability and Modulation
Accuracy measurement (see
With all other measurements this command causes a query error.
Suffix:
<n>
Parameters:
<Mode>
Operating Manual 1176.7610.02 ─ 02
Remote Commands for Bluetooth Measurements (K8)
See "Carr Freq Stability"
CONFigure:​ B TOoth:​ M EASurement​
.
irrelevant
MINimum | MAXimum | AVERage
*RST: -
For the first steps refer to
ple", on page 127
CONF:BTO:MEAS CFST
Activates the Carrier Frequency Stability and Modulation Accu-
racy measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:CFST:FERR:BLOC? AVER
Reads the maximum average frequency deviation of all blocks.
Query only
BT
See "Carr Freq Stability"
CONFigure:​ B TOoth:​ M EASurement​
.
irrelevant
MINimum | MAXimum | AVERage
*RST: -
CALCulate subsystem
on page 47
on page 96).
chapter 4.14, "Programming Exam-
on page 47
on page 96).
74