Table of Contents
Advertisement
®
R&S
FSV-K8
The abbreviation DPSK stands for "Differential Phase Shift Keying".
Remote command:
CONFigure: B TOoth: R TPower: D AVerage: S TOP
Spurious Emissions
Opens a submenu to configure the Spurious Emissions measurement. For further
details refer to
on page 29.
Remote command:
CONF:BTO:MEAS IBS, see
CALCulate<n>: B TOoth: I BSemissions: [ List]?
CALCulate<n>: B TOoth: I BSemissions: E XCeptions?
CALCulate<n>: B TOoth: I BSemissions: H ADJacent?
Channel ← Spurious Emissions
Opens an edit dialog box to enter the transmission channel number. From the number
of the channel the center frequency is calculated in accordance to the RF Test Specifi-
cation. The default setting is channel number 0.
Principally, setting the channel number has the same effect as changing the center fre-
quency. The major difference is that the center frequency is not limited to available fre-
quency band values, i.e. values outside the frequency band and between the discrete
channels can be selected (see also
Remote command:
CONFigure: B TOoth: C HANnel
Meas Setup ← Spurious Emissions
Opens a dialog box for common measurement settings, see
Find Sync ← Spurious Emissions
Opens a dialog box to set the signal processing functions of the analyzer, see
Sync"
No. of ACP Chan (TX Spec ACLR, Spurious Emissions) ← Spurious Emissions
Opens an edit dialog box to enter the number of adjacent channels, for which the
power is to be measured. The values range from 0 to 78. A minimum value of 3 is rec-
ommended. The default setting is 78 (all channels).
As with the ACP measurement of the basic instrument firmware this value refers to the
number of adjacent channels on one side of the TX channel. This means that with a
selected value of 10 the analyzer will measure in total 21 channels (10 lower channels
+ TX channel + 10 upper channels).
The frequency range required for the measurement is set up automatically. The center
frequency will also be adapted automatically dependent on the selected TX channel.
Operating Manual 1176.7610.02 ─ 02
Instrument Functions for Bluetooth Measurements (K8)
chapter 3.1.7, "In–band Spurious Emissions (EDR)
CONFigure: B TOoth: M EASurement
on page 37.
Softkeys of the Bluetooth Menu
on page 100
on page 76
Center
softkey in the "Frequency" menu).
on page 94
measurement",
on page 96
on page 77
on page 78
"Meas Setup"
on page 36.
"Find
46
Advertisement
Chapters
Table of Contents
