Measurement Type; Primary Sensor, Secondary Sensor; Primary Sensor Config, Secondary Sensor Config; Channel Calculation Function - R&S NRX Series User Manual

®
R&S NRX

Measurement Type

Sets the measurement type.
Remote command:
CALCulate<Measurement>:TYPE

Primary Sensor, Secondary Sensor

Available for continuous average, burst average, trace, pulse analysis, time gate, time-
slot measurements.
Assigns the primary or secondary sensor. You can choose any of the sensors that are
connected to a sensor port of the R&S NRX. The port letter, to which the sensor is con-
nected, is displayed in front of the hostname of the sensor.
Example: C: NRP33SN-104711; C is the port, NRP33SN-104711 is the sensor name.
If "Prim. Single" is set under
disabled.
If a power sensor does not support the selected
is displayed. See also
Remote command:
CALCulate<Measurement>[:CHANnel<Channel>]:SENSe:INDex
[SENSe<Sensor>:]CATalog?

Primary Sensor Config, Secondary Sensor Config

Available for continuous average, burst average, trace, pulse analysis, time gate, time-
slot measurements.
For configurating the primary and secondary sensors, assigned under
Secondary
See

Channel Calculation Function

Available for continuous average, burst average, trace, pulse analysis, time gate, time-
slot measurements.
You can combine the measured values from the primary and secondary sensor using a
mathematical function. The primary and secondary sensors are assigned under
mary Sensor, Secondary
Apart from the "Prim. Single" function, all functions require values measured by two
sensors.
User Manual 1178.5566.02 ─ 07
Chapter 5.5, "Settings
Sensor.
Chapter 8, "Sensor Configuration",
Sensor.
Configuration for All Measurement Types
on page 231
Channel Calculation Function, the secondary sensor is
Measurement
Conflict",
on page 232
on page 113.
Measurement Settings Dialog
Type, a settings conflict
on page 47.
on page 232
Primary Sensor,
Pri-
67