Configure:btooth:pbsco; Configure:btooth:pclass; Configure:btooth:power:average:start - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
CONFigure:BTOoth:PBSCo <NoBytes>
This command selects the number of payload bytes that are transmitted in a packet.
Parameters:
<NoBytes>
Example:
Mode:
Manual operation:
CONFigure:BTOoth:PCLass <Class>
This command selects the power class for the Output Power measurement. The power
class defines the limits for the output power measurement.
Parameters:
<Class>
Example:
Mode:
Manual operation:
CONFigure:BTOoth:POWer:AVERage:STARt <Position>
This command defines the start position for the calculation of the average power of a
burst.
Note:
Depending on the setting FIND SYNC ON or OFF (see
SYNC:​ S TATe​
length or the 3 dB points according to the RF Test Specification. As a result there are
different areas within the burst for calculating the average power:
Parameters:
<Position>
Operating Manual 1176.7610.02 ─ 02
Remote Commands for Bluetooth Measurements (K8)
CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
1 – 1000
*RST: 1
CONF:BTO:PBSC 50
Selects the number of payload bytes.
BT
See "Packet Bytes SCO"
1 to 3
*RST: 1
CONF:BTO:PCL 3
Selects power class 3
BT
See "Power Class"
on page 121) the burst is either defined by the p0 bit and the packet
0 to 100PCT
*RST: 20%
on page 37
on page 37
[SENSe]:​ D DEMod:​ S EARch:​
98