Calculate<N>:Btooth:opower[:Peak]; Calculate<N>:Btooth:opower:average - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
Mode:
Manual operation:
CALCulate<n>:BTOoth:OPOWer[:PEAK]?
This command reads the peak value of the Output Power measurement according to
the BLUETOOTH standard.
Note:
This command is only available with active Output Power measurement (see
CONFigure:​ B TOoth:​ M EASurement​
causes a query error.
Suffix:
<n>
Example:
Usage:
Mode:
Manual operation:
CALCulate<n>:BTOoth:OPOWer:AVERage? <Mode>
This command reads the average value of the Output Power measurement according
to the Bluetooth standard.
With a sweep count value of ≥ 1
mode "Clear/Write" (DISPlay[:WINDow<n>]:TRACe<t>:MODE) the selected num-
ber of measurements is performed when a single sweep is started
IMMediate]​
determined. If only a single measurement is performed, the minimum and maximum
value are identical.
Note:
This command is only available with active Output Power measurement (see
CONFigure:​ B TOoth:​ M EASurement​
causes a query error.
Suffix:
<n>
Operating Manual 1176.7610.02 ─ 02
Remote Commands for Bluetooth Measurements (K8)
BT
See "Modulation Char"
.
irrelevant
For the first steps refer to
ple", on page 127
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:OPOW?
Queries the output power result.
Query only
BT
See "Output Power"
(CONFigure:​ B TOoth:​ S WEep:​ C OUNt​
) . During these measurements the minimum and maximum values are
.
irrelevant
on page 41
on page 96). With all other measurements it
chapter 4.14, "Programming Exam-
on page 35
on page 96). With all other measurements it
CALCulate subsystem
) and trace
(INITiate<n>[:​
83