R&S FSV-K8 Operating Manual page 88

®
R&S FSV-K8
Return values:
<Result>
Example:
Usage:
Mode:
4.1.2 CALCulate:DELTamarker Subsystem (BLUETOOTH, K8)
CALCulate<n>:DELTamarker<m>:Y?
CALCulate<n>:DELTamarker<m>:Y?
This command queries the measured value of a delta marker. The corresponding delta
marker is activated, if necessary. The output is always a relative value referred to
marker 1 or to the reference position (reference fixed active).
To obtain a correct query result, a complete sweep with synchronization to the sweep
end must be performed between the activation of the delta marker and the query of the
y value. This is only possible in single sweep mode.
Depending on the unit defined with CALC:UNIT:POW or on the activated measuring
functions, the query result is output in the units below:
Table 4-1: Bluetooth measurements
Parameter, measuring function or result display
OUTPUT POWER result display (R&S FSV–K8)
TX SPECTRUM ACP result display (R&S FSV–K8)
MODULATION CHARACTERISTICS result display
(R&S FSV–K8)
INITIAL CARR FREQ TOL result display (R&S FSV–K8)
CARRIER FREQ DRIFT result display (R&S FSV–K8)
RELATIVE TX POWER (R&S FSV–K8)
IN–BAND SPURIOUS EMISSIONS (R&S FSV–K8)
Operating Manual 1176.7610.02 ─ 02
Remote Commands for Bluetooth Measurements (K8)
0
PASS
1
FAIL
INST:SEL BTO
Activates the Bluetooth Measurements option
INIT:CONT OFF
Selects single sweep operation
CONF:BTO:MEAS OPOW
Activates Output Power measurement
INIT;*WAI
Starts the measurement with synchronization
CALC:BTO:STAT?
Queries the status
Query only
BT
.................................................................................88
CALCulate subsystem
Output unit
dB
dB
Hz
Hz
Hz
dB
dB
88