Calculate<N>:Btooth:mchar:df<Delta>:Maximum - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
Note:
This command is only available with active Modulation Characteristics measurement
(see
ments this command causes a query error.
Suffix:
<n>
<Delta>
Parameters:
<Type>
Example:
Usage:
Mode:
Manual operation:
CALCulate<n>:BTOoth:MCHar:DF<Delta>:MAXimum? <Mode>
This command determines the maximum frequency deviation for different bit patterns
of the payload.
Note:
This command is only available with active Modulation Characteristics measurement
(see
ments this command causes a query error.
Suffix:
<n>
Operating Manual 1176.7610.02 ─ 02
CONFigure:​ B TOoth:​ M EASurement​
.
irrelevant
1 | 2
the frequency deviation and the bit pattern:
1 = Δf1
2 = Δf2
MINimum | MAXimum
*RST:
For the first steps refer to
ple", on page 127
CONF:BTO:MEAS MCH
Activates the Modulation Characteristics measurement.
CONF:BTO:SWE:COUN 20
Initiates the sweep counter with 20.
... EUT emits bit pattern 1111000
INIT:IMM;*WAI
Starts the measurement with synchronization and erase previ-
ous measurement results.
CALC:BTO:MCH:DF1:AVER? MIN
Queries minimum value "11110000".
Query only
BT
See "Modulation Char"
CONFigure:​ B TOoth:​ M EASurement​
.
irrelevant
Remote Commands for Bluetooth Measurements (K8)
on page 96). With all other measure-
: 11110000
avg
: 10101010
avg
-
chapter 4.14, "Programming Exam-
on page 41
on page 96). With all other measure-
CALCulate subsystem
80