Calculate<N>:Btooth:ibsemissions:exceptions - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
Note:
This command is only available with active In–band Spurious Emissions measurement
(see
ments this command causes a query error.
Suffix:
<n>
Example:
Usage:
Mode:
Manual operation:
CALCulate<n>:BTOoth:IBSemissions:EXCeptions?
This command reads the number of results that exceeded the specified limits in the In–
band Spurious Emissions measurement.
Note:
This command is only available with active In–band Spurious Emissions measurement
(see
ments this command causes a query error.
Suffix:
<n>
Example:
Usage:
Mode:
Operating Manual 1176.7610.02 ─ 02
CONFigure:​ B TOoth:​ M EASurement​
.
irrelevant
For the first steps refer to
ple", on page 127
CONF:BTO:MEAS IBS
Activates the In–band Spurious Emissions measurement.
CONF:BTO:CHAN 7
Adjust the TX channel number.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:IBS?
Reads the results of the In–band Spurious Emissions measure-
ment.
Query only
BT
See "Spurious Emissions"
CONFigure:​ B TOoth:​ M EASurement​
.
irrelevant
For the first steps refer to
ple", on page 127
CONF:BTO:MEAS IBS
Activates the In–band Spurious Emissions measurement.
CONF:BTO:CHAN 7
Adjust the TX channel number.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:IBS:EXC?
Reads the number of results that exceeded the specified limits.
Query only
BT
Remote Commands for Bluetooth Measurements (K8)
on page 96). With all other measure-
chapter 4.14, "Programming Exam-
on page 46
on page 96). With all other measure-
chapter 4.14, "Programming Exam-
CALCulate subsystem
77