®
R&S
FSV-K8
This command is only available with active Differential Phase Encoding measurement
(see
ments this command causes a query error.
Suffix:
<n>
Example:
Usage:
Mode:
Manual operation:
CALCulate<n>:BTOoth:DPENcoding:NERRor?
This command reads the number of passed packets in the Differential Phase Encoding
measurement.
Note:
This command is only available with active Differential Phase Encoding measurement
(see
ments this command causes a query error.
Suffix:
<n>
Example:
Usage:
Mode:
Manual operation:
CALCulate<n>:BTOoth:IBSemissions:[List]?
This command reads the power of all adjacent channels in the In–band Spurious Emis-
sions measurement.
Operating Manual 1176.7610.02 ─ 02
CONFigure: B TOoth: M EASurement
.
irrelevant
For the first steps refer to
ple", on page 127
CONF:BTO:MEAS DPEN
Activates the Differential Phase Encoding measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:DPEN:BER?
Reads the bit error rate.
Query only
BT
See
"Diff Phase"
CONFigure: B TOoth: M EASurement
.
irrelevant
For the first steps refer to
ple", on page 127
CONF:BTO:MEAS DPEN
Activates the Differential Phase Encoding measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:DPEN:NERR?
Reads the number of passed packets.
Query only
BT
See
"Diff Phase"
Remote Commands for Bluetooth Measurements (K8)
on page 96). With all other measure-
chapter 4.14, "Programming Exam-
on page 48
on page 96). With all other measure-
chapter 4.14, "Programming Exam-
on page 48
CALCulate subsystem
76