Configure:btooth:sweep:time; Configure:btooth:sweep:time:auto; Configure:btooth:trace<T>:Mode - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
CONFigure:BTOoth:SWEep:TIME <Duration>
This command defines the duration of a sweep sequence for the active Bluetooth mea-
surement.
Parameters:
<Duration>
Example:
Mode:
Manual operation:
CONFigure:BTOoth:SWEep:TIME:AUTO <Mode>
This command couples the sweep time to the settings according to the RF Test Speci-
fication.
Note:
The setting is valid only for the currently active measurement (see
BTOoth:​ M EASurement​
ments.
Parameters:
<Mode>
Example:
Mode:
Manual operation:
CONFigure:BTOoth:TRACe<t>:MODE <Mode>
This command defines the way of displaying and evaluating the measurement curves
for the selected Bluetooth measurement. WRITe corresponds to manual operating
mode Clr/Write.
Operating Manual 1176.7610.02 ─ 02
Remote Commands for Bluetooth Measurements (K8)
CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
1us to [130560us / (points per symbol)]
*RST: AUTO is set to ON
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
CONF:BTO:SWE:TIME 10MS
Sets a sweep time of 10 ms.
BT
See "Sweeptime Manual (TX Spec ACLR)"
See "Meas Time Manual"
on page 96) and independent of the other Bluetooth measure-
ON | OFF
*RST: ON
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
CONF:BTO:SWE:TIME:AUTO ON
Switches the sweep time coupling on.
BT
See "Sweeptime Auto (TX Spec ACLR)"
See "Meas Time Auto"
on page 54
on page 54
CONFigure:​
on page 54
on page 54
103