R&S FSV-K8 Operating Manual page 126

®
R&S FSV-K8
TRIGger<n>[:SEQuence]:LEVel:IFPower <TriggerLevel>
This command defines the power level at the third intermediate frequency that must be
exceeded to cause a trigger event. Note that any RF attenuation or preamplification is
considered when the trigger level is analyzed. If defined, a reference level offset is also
considered.
Suffix:
<n>
Parameters:
<TriggerLevel>
Example:
Manual operation:
TRIGger<n>[:SEQuence]:SLOPe <Type>
This command selects the slope of the trigger signal. The selected trigger slope
applies to all trigger signal sources.
Suffix:
<n>
Parameters:
<Type>
Example:
Manual operation:
TRIGger<n>[:SEQuence]:SOURce <Source>
This command selects the trigger source.
For details on trigger modes refer to the "Trg/Gate Source" softkey in the base unit
description.
Suffix:
<n>
Operating Manual 1176.7610.02 ─ 02
Remote Commands for Bluetooth Measurements (K8)
.
irrelevant
*RST: -20 dBm
TRIG:LEV:IFP -30DBM
See "Trg/Gate Level" on page 62
.
irrelevant
POSitive | NEGative
*RST: POSitive
TRIG:SLOP NEG
See "Trg/Gate Polarity"
.
irrelevant
TRIGger subsystem
on page 63
126