Calculate<N>:Btooth:cfstability:count; Calculate<N>:Btooth:cfstability:devm:[Rms] - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
Manual operation:
CALCulate<n>:BTOoth:CFSTability:COUNt?
This command reads the number of measured blocks during or after a measurement.
Note:
This command is only available with active Carrier Frequency Stability and Modulation
Accuracy measurement (see
With all other measurements this command causes a query error.
Suffix:
<n>
Example:
Usage:
Mode:
Manual operation:
CALCulate<n>:BTOoth:CFSTability:DEVM:[RMS]? <Mode>
This command reads the root mean square (RMS) of the differential error vector mag-
nitude (DEVM) in the Carrier Frequency Stability and Modulation Accuracy measure-
ment.
Note:
This command is only available with active Carrier Frequency Stability and Modulation
Accuracy measurement (see
With all other measurements this command causes a query error.
Suffix:
<n>
Parameters:
<Mode>
Operating Manual 1176.7610.02 ─ 02
Remote Commands for Bluetooth Measurements (K8)
See "Carr Freq Drift" on page 43
CONFigure:​ B TOoth:​ M EASurement​
.
irrelevant
For the first steps refer to
ple", on page 127
CONF:BTO:MEAS CFST
Activates the Carrier Frequency Stability and Modulation Accu-
racy measurement.
INIT;*WAI
Starts the measurement with synchronization.
CALC:BTO:CFST:COUNt?
Reads the number of measured blocks.
Query only
BT
See "Carr Freq Stability"
CONFigure:​ B TOoth:​ M EASurement​
.
irrelevant
MINimum | MAXimum | AVERage
*RST: -
CALCulate subsystem
on page 96).
chapter 4.14, "Programming Exam-
on page 47
on page 96).
71