Configure:btooth:rtpower:gaverage:start; Configure:btooth:rtpower:gaverage:stop - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
Parameters:
<Time>
Example:
Mode:
Manual operation:
CONFigure:BTOoth:RTPower:GAVerage:STARt <Time>
This command sets the start time for the power measurement of the GFSK sections of
the packet.
Note:
This command is only available with active Relative Transmit Power measurement
(see
Parameters:
<Time>
Example:
Mode:
Manual operation:
CONFigure:BTOoth:RTPower:GAVerage:STOP <Time>
This command sets the stop time for the power measurement of the GFSK sections of
the packet.
Note:
This command is only available with active Relative Transmit Power measurement
(see
Parameters:
<Time>
Example:
Mode:
Manual operation:
Operating Manual 1176.7610.02 ─ 02
0 to 100%
*RST:
CONF:BTO:RTP:DAV:STOP 80
Sets the stop time for the power measurement of the DPSK sec-
tions of the packet.
BT
See "DPSK Stop"
CONFigure:​ B TOoth:​ M EASurement​
0 to 100%
*RST:
CONF:BTO:RTP:GAV:STAR 20
Sets the start time for the power measurement of the GFSK sec-
tions of the packet.
BT
See "GFSK Start"
CONFigure:​ B TOoth:​ M EASurement​
0 to 100%
*RST:
CONF:BTO:RTP:GAV:STOP 80
Sets the stop time for the power measurement of the GFSK sec-
tions of the packet.
BT
See "GFSK Stop"
Remote Commands for Bluetooth Measurements (K8)
CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
90%
on page 45
on page 96).
10%
on page 45
on page 96).
90%
on page 45
101