Configure:btooth:cfstability:bcount; Configure:btooth:channel - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
Note:
This setting is only valid for the currently active measurement (see
BTOoth:​ M EASurement​
measurements.
Parameters:
<Mode>
Example:
Mode:
Manual operation:
CONFigure:BTOoth:CFSTability:BCOunt <NoBlocks>
This command sets the number of blocks to be measured.
Note:
This command is only available with active Carrier Frequency Stability and Modulation
Accuracy measurement (see
Parameters:
<NoBlocks>
Example:
Mode:
Manual operation:
CONFigure:BTOoth:CHANnel <Channel>
This command selects the frequency channel for the measurements according to the
Bluetooth standard.
Parameters:
<Channel>
Example:
Mode:
Operating Manual 1176.7610.02 ─ 02
Remote Commands for Bluetooth Measurements (K8)
CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
on page 96) and it is independent of the other Bluetooth
ON | OFF
*RST: ON
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS ACLR
Activates the Adjacent Channel Power measurement.
CONF:BTO:BAND:VID:AUTO ON
Switches the VBW coupling on.
BT
See "Video BW Auto (TX Spec ACLR, Spurious Emissions)"
on page 55
CONFigure:​ B TOoth:​ M EASurement​
0 to 1,000,000
*RST: 200
CONF:BTO:CFST:BCO 1000
Selects 1000 blocks to be measured.
BT
See "Block Count (Carr Freq Stability)"
0 to 78
*RST: 0
CONF:BTO:CHAN 20
Selects channel 20
BT
CONFigure:​
on page 96).
on page 48
94