Configure:btooth:detector<1; Configure:btooth:ibsemissions:acpairs - R&S FSV-K8 Operating Manual

®
R&S FSV-K8
Manual operation:
CONFigure:BTOoth:DETector<1...4>[:FUNCtion] <Detector>
This command selects the detector for the currently selected Bluetooth measurement.
The numeric suffix assigns the detector to a trace (1 to 4).
Note:
The RMS detector is not available for the measurements Modulation Characteristics,
Initial Carrier Frequency Tolerance, and Carrier Frequency Drift (see
BTOoth:​ M EASurement​
measurement (see
ent of other Bluetooth measurements.
Parameters:
<Detector>
Example:
Mode:
Table 4-2: RST value depending on measurement type
Measurement type
Output Power
Adjacent Channel Power
EDR Rel TX Power
EDR In-band Spurious Emissions
Modulation Characteristics
Initial Carrier Frequency Tolerance
Carrier Frequency Drift
EDR Differential Phase Encoding
EDR Carrier Frequency Stability and Modulation Accuracy
CONFigure:BTOoth:IBSemissions:ACPairs <NoChannels>
This command selects the number of adjacent channel pairs during the In–band Spuri-
ous Emissions measurement. The number of adjacent channels will be limited as soon
as the border of the Bluetooth frequency band is reached.
Note:
This command is only available with active In–band Spurious Emissions measurement
(see
Operating Manual 1176.7610.02 ─ 02
See "Channel"
on page 96).The setting is valid for the currently selected
CONFigure:​ B TOoth:​ M EASurement​
APEak | NEGative | POSitive | SAMPle | RMS | AVERage
*RST:
INST:SEL BTO
Activates the Bluetooth Measurements option.
CONF:BTO:MEAS OPOW
Activates the Output Power measurement.
CONF:BTO:DET2 RMS
Sets the detector for trace 2 to RMS.
BT
CONFigure:​ B TOoth:​ M EASurement​
Remote Commands for Bluetooth Measurements (K8)
CONFigure:BTOoth Subsystem (BLUETOOTH, K8)
on page 36
see table below
on page 96).
CONFigure:​
on page 96) and independ-
RST value
PEAK
AVER
APEAK
95